Buzz World 365 Logo

Einstellhilfe für das Bandsägeblatt

Sep 12, 2022

Einstellhilfe für das Bandsägeblatt

a warm welcome here from drobny log cabin to another project yes a million viewers i invite you to another project which of course is again a mini project now i have built a part here which is a device to set the saw blade ie directly the

bands

aw to adjust the parallel fixture should be straight and the saw blade should be straight yes I invite you to take a look at this project here of course you could have done it a bit with magnets but I'll explain why I have the pack later. I wish you a lot of fun with the video.
einstellhilfe f r das bands geblatt
I looked at the spectators. That was from this setup. old the two screws have the same height it is so logical it must be so I have come across a divorced magnet because by a magnet when I show the saw blade as I do here now she has a donation and due to these fluctuations the teeth are slightly offset so Niemann fingers are slightly offset in time and because of this offset of this saw blades you get that saw blade or at least the bar was not set correctly and there was a little slate notch so I did a notch and from behind is because this maybe you can see that planned with the spd well attached so i think you might have this alternative or at least this solution can be improved a bit by setting it up.
einstellhilfe f r das bands geblatt
I have to see how that goes in the future, but like I said, the distro mini project might be there for some suggestions. i liked this little mini project kinda right away yeah complete me just jessica until next time until next project until then in all the good stuff stay healthy and i'm off
einstellhilfe f r das bands geblatt
Trending